2011-2019 Ford Explorer Driver Side Rear Back Door Front Weatherstrip

It is important to note that this weatherstrip is not for the front doors, but rather goes at the front of the door opening on the back driverr Side door. It helps to create a tight seal between the door and the vehicle's body, preventing water, air, and noise from entering the cabin

This Driver Side Rear Back Door Front Weatherstrip is an essential auto part designed for 2011-2019 Ford Explorer models. It helps to prevent water, air, and noise from entering the vehicle cabin, creating a tight seal between the back door on the passenger side and the vehicle's body. This Genuine OEM part comes in the manufacturer's packaging and is the same part sold at the new car dealership, ensuring its reliability and high-quality performance. This weatherstrip is not an aftermarket part, so you can be confident that it will fit your vehicle perfectly and provide long-lasting protection.

Installation Instructions

To replace the old weatherstrip with the new Passenger Side Rear Back Door Front Weatherstrip, follow these simple steps:

1. Clean the area around the door opening and remove any debris or old adhesive.
2. Remove the old weatherstrip carefully by peeling it away from the door frame.
3. Apply a thin layer of weatherstrip adhesive to the back of the new weatherstrip and to the door frame.
4. Press the new weatherstrip into place firmly and hold it for a few minutes to allow the adhesive to set.
5. Check to make sure the weatherstrip is securely in place and functioning properly.

This installation process typically takes 30-60 minutes and requires basic mechanical skills. You will need weatherstrip adhesive, a clean cloth, and a sharp knife or scissors to remove the old weatherstrip.

Vehicle Fitment