2010-2014 Ford F-150 Tailgate Back Up Camera Housing and Emblem Kit

THE CAMERA IS NOT INCLUDED

The rear Tailgate Reverse Back-Up Camera Housing Bezel & Emblem is a direct fit for the following:

Note: Housing Bezel & Emblem Have Been Updated Since The Original Ones Were Produced. It will look very different from the original, but fits the same.

2010-2014 Ford F-150

-Includes Both Back-Up Camera Housing Bezel & Emblem.

The Camera and the screws are not included. For both of these, you can re-use your old ones as nothing has changed in the design of the hardware or camera.

Installation Instructions:

Installing a new Ford tailgate backup camera housing and emblem kit on a 2010-2014 Ford F-150 can be done with just a few basic tools. Here are the steps to follow:

Tools Needed:

• Socket wrench set
• Pliers
• Flat-head screwdriver

Skill Level:

• Moderate

Estimated Time:

• 1-2 hours

1. Begin by removing the old tailgate emblem and camera housing from the tailgate. Use a flat-head screwdriver to gently pry away the clips that hold the emblem and housing in place. Be careful not to damage the surrounding area or the parts themselves.

2. Once the old emblem and housing are removed, clean the surface of the tailgate where the new parts will be installed. Use a clean, dry cloth to remove any dirt or debris.

3. Take the new Ford tailgate back up camera housing and emblem kit and place the camera housing into the tailgate, making sure it is properly aligned. Use a socket wrench set to securely fasten the camera housing into place with the supplied screws.

4. Connect the camera's wiring harness to the appropriate connector on the vehicle. You may need to route the harness through the tailgate and into the cabin of the truck.

5. Take the new emblem and place it onto the tailgate, aligning it with the camera housing. Gently press the emblem into place, securing the clips onto the tailgate.

6. Once the new parts are securely attached, check them for proper fit and alignment. Make any necessary adjustments.

7. Finally, test the new camera to ensure it is working properly. You may need to activate the camera by shifting the truck into reverse.

Note: It is recommended to consult your vehicle's owner's manual for specific instructions and safety precautions before attempting this installation.