Ford 2008-2011 Ford Focus Steering Column Ignition Housing Flange Switch Manual Transmission Only
$ 99.80

Genuine Part. Made by the same manufacturer who built your vehicle. the absolute highest quality part available.


Note: This is a special order part and usually ships in 1-2 days. Shipping Carrier Delays Are Possible during the Holiday Season.


cancel at any time and get a full refund up until the time we ship your package.

Genuine Part. Exact Replacement. No modifications required. Includes 3 year Warranty, Easy Returns. 

Part Details and Fitment 

Steering Column Housing Flange w/ Switch is a Direct Fit For The Following:
  • 2008-2011 Ford Focus MANUAL TRANSMISSION ONLY. (INSTALLING ON A VEHICLE WITH AN AUTOMATIC TRANSMISSION WILL CAUSE SEVERE ENGINE AND TRANSMISSION DAMAGE.

THIS PART FITS

Make Model Year Body & Trim Engine & Transmission
Ford Focus 2011 S, SE, SEL, SES 2.0L L4 - Gas
Ford Focus 2010 S, SE, SEL, SES 2.0L L4 - Gas
Ford Focus 2009 S, SE, SEL, SES 2.0L L4 - Gas
Ford Focus 2008 S, SE, SES 2.0L L4 - Gas
Install Instructions

  1. Disconnect the negative battery terminal.
  2. Remove the steering columns, top and bottom cover and the drivers knee panel under the dash.
  3. Unplug the starter switch on the left side of the column.
  4. Remove the security ring from around the key tumbler by unsnapping it from the housing. Electrical is done.
  5. Three small bolts hold the lock housing onto the turn signal assembly. One bolt is on top, one on the bottom left and one on the right/front. You must use your key to unlock the steering column and turn the wheel to the right to allow access the right/front bolt. Remove all three.
  6. Last, on top of the steering column you will notice an aluminum collar that holds the lock housing assembly in place. On the right side of this collar it is bolted to the steering column by only one anti-theft bolt without a head. (The head of the bolt is gone, designed to break off at the factory when installed for anti-theft reasons so normal tools cannot be used to remove it.) Ours had yellow paint on it. Use a small, very sharp chisel to tap the side of the bolt counter clockwise to loosen it and take it out. DO NOT LOSE IT! You cannot get a replacement.
  7. You should be able to lift up the aluminum collar and remove the old housing assembly.
  8. To use your existing keys you must remove the old tumbles. Put the key into the lock cylinder and turn it one notch only, to the accessory position. On top of the cylinder is a small hole. Put a small torx socket (or nail) in it, push down, pull on the key to remove the tumbler cylinder from the old housing. Put the old tumbler in the new lock housing assembly.
  9. Reverse everything and you are done.


Customer Reviews

Based on 24 reviews
92%
(22)
4%
(1)
4%
(1)
0%
(0)
0%
(0)
C
C.B.
Installation Ease: A little bit of mechanical ability is required
Installation time : 30 Minutes or More
Tools Required: Common Household Tools
Part Quality: Excellent Quality
Happy to find the part!
S
S.G.A.
Verified Customer Review

Popular Parts You may Be Interested In