2002-2011 Ford Ranger Manual Transmission Gear Shifter Lever Boot Cup Holder - Ford

Are you looking to upgrade the gear shifter lever boot cup holder in your 2002-2011 Ford Ranger with manual 5 speed transmission? Look no further than this manual transmission gear shifter lever boot cup holder!

Installation Instructions:

Tools Needed:

• Socket Set
• Screwdriver

Skill Level: Intermediate

Installation Time: Approximately 1 hour

Note: Before starting the installation, ensure that the vehicle is in park or neutral and the emergency brake is engaged.

1. Use a socket set to remove the center console from the vehicle. This will provide access to the gear shifter lever boot and cup holder.
2. Use a screwdriver to carefully pry off the old gear shifter lever boot from the center console.
3. Install the new Genuine Ford gear shifter lever boot by carefully sliding it over the gear shifter lever and securing it to the center console.
4. Install the new Genuine Ford cup holder by aligning the mounting holes with the holes in the center console and securing it with screws.
5. Reinstall the center console in the vehicle by securing it with screws.

It is important to note that this installation requires intermediate-level skills and should not be attempted by individuals with limited automotive knowledge. The job can take approximately 1 hour to complete, depending on the installer's skill level and familiarity with the vehicle. Always make sure to properly secure the center console to prevent any rattling or movement while driving.