2002-2006 Camry Back Deck Speaker Grille Replacement Instructions

August 31, 2020

2002-2006 Camry Back Deck Speaker Grille Replacement Instructions

Step By Step Instructions on replacing the rear deck speaker covers on 2000-2006 Camry.
(Note Have a Shop Vac Ready, You are going to need it).
Installation Instructions:
1. Wedge a flat head screwdriver under the edge of the speaker grill.
2. Pry up on the grill. There are several retaining clips holding the grill in place. You may end up breaking these clips off to remove the grill. It's okay to do so because you will be replacing these covers with new ones.
3.Work the screwdriver all the way around the edge of the speaker cover. If you can get your fingers underneath the cover, it may make it easier to pry the cover up. Once the cover is removed, clear the mounting brakes of any broken retainer clip pieces.
4. Slide the new speaker cover into place. Push on the cover until the speaker cover snaps into place.
Be careful! Many companies and dealers are still selling the old design because it is cheaper and they can make more profit. If you get the old design you will just have the same problem again in just a few months. We only sell the new design grilles.

Also be sure to have a vacuum handy when all the little pieces fall down into the speaker, you'll want to vacuum those pieces out


Leave a comment

Comments will be approved before showing up.


Also in Genuine Auto Parts News

2013-2017 Dodge Ram Console Lower Latch Broken? The Fix is easy and Cheap!
2013-2017 Dodge Ram Console Lower Latch Broken? The Fix is easy and Cheap!

September 14, 2020

Do you have the Full console on your 2013-2017 Ram? Is the Console Latch Broken? 

There is an easy fix, its just a-few screws and it is very affordable to fix with a new OEM part!

View full article →

2016 Mazda CX-5 Cup Holder Issues Resolved With New Parts
2016 Mazda CX-5 Cup Holder Issues Resolved With New Parts

September 11, 2020

Do you have a 2016 Mazda CX-5? Is Your Cup holder loose, cracked or broken?

The original cup holders were not very well made, and get brittle and crack from the heat. This Genuine Mazda replacement solves the problem. 

View full article →

2007-2013 Acadia or Traverse How To Fix Tail Gate Not Opening
2007-2013 Acadia or Traverse How To Fix Tail Gate Not Opening

August 31, 2020

View full article →

x